Mcallister
New member
Well I guess I'm one of the unlucky ones with the mk2 35mm. I just got my scope yesterday and I pulled it out of the packaging and flipped it on, played with it for maybe 5 minutes outside before I mounted it on my rifle. Then I went and sighted it in, no problems except the menu on the left where it should say 1-8 was blank except for the box that would show which menu your currently on but that came back after the menu timed out and I turned the menu knob again. At this point I'm pretty excited to use it in the field so I head out behind the house and try calling but nothing wants to play except the cows in the pasture. I head out to my next stand, turn the scope on and calibrate it then I go to look through it and the screen is completely blank except for the menus that are showing up on the screen. So I try to calibrate it a few times with no luck and the same outcome, I try cycling the power a few times with no luck and the exact same blank screen with the menu showing. Finally after letting it set for about 15 minutes I turn it on, calibrate it and it seems to be working fine so I leave it on for about a minute and I go to look through it and now it's completely off, black screen. I try cycling the power and absolutely nothing happens. Change out the brand new batteries with 4 different sets and still no power. I got it through tnvc so hopefully I can get ahold of them soon to get this replaced because I must say when this thing is working it absolutely blows my mind. Has anyone else had any problems with theirs?