SDCoyoteCaller
Active member
I put some Talley Lightweight one piece scope rings on a Savage 110 and when I placed the scope in the rings it doesn't fit all the way flush down in the rings. I can see a small gap between the bottom of the scope and the rings. I have never had this happen before, so I assume it isn't suppose to be that way. How can I correct this problem?
It is probably a problem with the screw holes not being lined up correctly on the gun instead of with the rings itself. Will I need to lap the rings to get the scope to line up correctly? If so, Where can I get a ring lapping kit?
Thanks for the help.
It is probably a problem with the screw holes not being lined up correctly on the gun instead of with the rings itself. Will I need to lap the rings to get the scope to line up correctly? If so, Where can I get a ring lapping kit?
Thanks for the help.
Last edited: