Finally got the scope mount system I ordered from Millett. Kind of wish I would have waited a couple days more because someone eventually suggested I go with the Weaver 61 bases and the Burris Zee rings with the inserts. Yep, I was in a big hurry to get this thing put together. Don't get me wrong, the Millett system looks nice and will work fine until I buy a scope with a 30mm tube on it. Then I'll get the scope mount rings with the inserts.
The OAL of the loads will exceed the length of the magazine, so I might be in the market for a .243 type magazine if anyone knows where to get one on the inexpensive side. Otherwise I may have to get out the old cutting torch and welder and go to work on the clip that's in there.
Here are a few pictures of the new Tikka Master Sporter in 22-250.
Rifle without the scope.
Right side view from ImageStation.com picture hosting site:
Left side view:
[This message has been edited by Silverfox (edited 04-16-2001).]
The OAL of the loads will exceed the length of the magazine, so I might be in the market for a .243 type magazine if anyone knows where to get one on the inexpensive side. Otherwise I may have to get out the old cutting torch and welder and go to work on the clip that's in there.
Here are a few pictures of the new Tikka Master Sporter in 22-250.
Rifle without the scope.
Right side view from ImageStation.com picture hosting site:
![feaa74be.jpg.orig.jpg](http://www.zing.com/picture/p54c58626fb9f1191b1e88139c9bb0bfe/feaa74be.jpg.orig.jpg)
Left side view:
[This message has been edited by Silverfox (edited 04-16-2001).]