Originally Posted By: CoyotejunkiGreg, do you turn the necks on your brass so the bushings are consistent? Or is your brass's neck thickness consistent enough where you always get the same neck tension?
I bought a crap load of Winchester brass years ago that I use that is very consistent. When I venture out into the other brands I do them by head stamp. I haven't seen much variance in thickness enough to make a difference. I do use different bushings for different brass though. If the brass is work hardened I will go an extra 0.0005 smaller in sizing.
Greg
I bought a crap load of Winchester brass years ago that I use that is very consistent. When I venture out into the other brands I do them by head stamp. I haven't seen much variance in thickness enough to make a difference. I do use different bushings for different brass though. If the brass is work hardened I will go an extra 0.0005 smaller in sizing.
Greg