Fitch
New member
I just took the magazine on my CZ527 Hornet apart. I'd like to modify it to accept cartridges about 0.1" longer than it will currently.
It looks like it should be relatively easy to do that but before I do anything not recoverable I thought I'd check to see if anybody has done it.
It has a block of plastic inside the back of the magazine that shortens it. Looks like that is pinned in place with two pins. What I'm thinking of doing is removing that block of plastic and replacing it with a shop made aluminum one that is ~0.1" thinner front to back. With that done, I'd bend up a new follower to fit and reassemble it with the stock magazine spring.
Anybody done something like this to the CZ Hornet magazine?
Thanks
Fitch
It looks like it should be relatively easy to do that but before I do anything not recoverable I thought I'd check to see if anybody has done it.
It has a block of plastic inside the back of the magazine that shortens it. Looks like that is pinned in place with two pins. What I'm thinking of doing is removing that block of plastic and replacing it with a shop made aluminum one that is ~0.1" thinner front to back. With that done, I'd bend up a new follower to fit and reassemble it with the stock magazine spring.
Anybody done something like this to the CZ Hornet magazine?
Thanks
Fitch