@Gman757 Sorry for the late question, but just ran across this post with very helpful info after recently joining this great forum. I’m currently rebuilding my trap gate system and working in an RTU5024 3g/4g gate opener/switch and swapping out the KT-G3A circuit board that has quit working after a few years in service. My three questions for Gman757 and/or anyone else willing to jump in are:
1) In the drawing, there is a four conductor wiring bus shown. Can you possibly send a link to this on Amazon? They have different types and I’m not sure which is proper.
2) I also have a solar panel and controller module (Top Solar Model TOPSCC-10A) and am curious where this would tie in to your wiring schematic drawing. It has three pos/neg wiring inputs/outputs on the controller unit labeled Solar, Battery & Load. Does the addition of a solar charger/controller mean that I need larger than a 4 conductor wiring bus?
3) Finally, has anyone used an RTU5024 unit as the cellular switch? The programming instructions online are very hard to follow and I am really struggling with this part.
Thanks for any input!