so i finally added a bolt gun to my toybox. went with the RPR in creedmore, for better or worse. the guns already bought, so that part is a "is what it is" thing at this point. it fit my price point well and its a chassis that feels reasonably familiar, so should be a relatively easy transition.

looking at a Venom 5-25x56 (34mm) for the optic.

i'm assuming i'm going to need close to AR style mount as far as optic height goes, but wanted to touch base and get some more knowledge before i pull the trigger on that part of this setup.

vortex has their precision matched rings with a 1.45" (base to center optic height). will this be enough to get into a comfortable optic height with this platform? my concern is being too low.

any feedback will be very helpful

TIA!

I looked at a bunch of these all set up and most have the objective bell about 1/4-3/8" above the hand guard. I'd use two rings instead of an AR style mount to spread the rings as far.apart as.posible and use a.set of tactical style rings with 6 screw caps and a.heavy clamp bolt.

As far as.scopes go, that is a.personal.decision, I've never dealt with high end Vortex scopes so no help there, never cared for Viper and below.

Not your exact set up but this is an rprrf with a 34mm scope mounted in an arken 1piece mount for some reference.

My buddy runs a one piece base on his RPR. He uses the Leupold base, but said if he did it again he would go with a one piece Warne, which is what I run on multiple guns now. You shouldn't have any problems of being too low with a 0 MOA base. RPR is set up just like an AR with how rail and optic sit in relation to your eyes. Crapshoot gives a good example in his picture. As for optic, I don't have any hands-on experience with the Venom, but to get all the features that scope has at that price point would be difficult to do and have good glass, so just be aware. I also haven't cared for anything Vortex from Viper line down from my own experience. Burris, Leupold, Sig Sauer, German Precision Optics I have all currently and am very happy.

Mine is a 20moa base with an arken sh4 scope.

My buddy runs a 20 MOA base as well, just for the fact he put it on a gun that was capable of really reaching out there, so he figured might as well make the optic capable of doing the same. I run a 0 MOA base since I have 90 MOA of adjustment (almost) in my scope.

You added a 20 moa base to the existing 20 moa rail that comes with it?

If you are talking to me, the rimfire comes with a 0moa rail.

Ahhh gotcha.

The Creedmoor comes with a 20 moa rail.

That's why i was confused

so maybe i didnt explain well in my first post - my big concern is getting the optic height right - relative to the human eye - more importantly not coming in too low


the venom is here, so time will prove the optic itself.

just want the mount to be as ideal height as i can.

That's the joy of adjustable cheek risers.

Still can't adjust lower than the min setting.

The non rimfire RPR doesn't have a drop comb to the stock.

Keep us informed of your choice of mount/rings and how it turned out.