Zeiss Optics

Predator Masters using UBB.threads ™ Infopop Corporation.
PM Gear Moon & Weather

Welcome to the Predator Masters Forums
Be sure to visit the main Predator Master website at

PM Gear
PM Gear
PM Gear
The Official Predator Masters Search Engine
Search Predator Masters

Topic Options
#3309902 - 01/02/23 10:06 AM Pulsar scalabe reticles
4trapr Offline
New Member

Registered: 03/15/13
Posts: 16
Loc: Northern IL
Trying to figure out the correct holdover distances that correspond to the drop points on the M56 reticle. This reticle is FFP, or "scales with the zoom". This is a Talion XQ38. It says 3.5 MOA between each dot. I am I correct in the drop in inches to the left side of the reticle (red 3.5, 7, 10.5...? These would be good at any zoom, correct? The red numbers of the right side of the reticle would be my approximate corresponding distances. Thanks [img:left]https://www.dropbox.com/s/2h97o8qj98d2cmx/Annotation%202023-01-02%20083813.jpg?dl=0[/img] https://www.dropbox.com/s/mrh7g148i6ufcdn/Annotation%202023-01-02%20084738.jpg?dl=0

#3309908 - 01/02/23 11:00 AM Re: Pulsar scalabe reticles [Re: 4trapr]
alf Offline
Die Hard Member II

Registered: 03/25/07
Posts: 1928
Loc: SW Wisconsin

As long as it is FFP, it doesn't matter what power you're on for holds. It does say reticle parameters apply to all magnifications.

I don't know what those yardages on the right line up with.


Moderator:  220_Swift, reb8600 

© 2000-2008 Predator Masters™, All Rights Reserved. This material may not be published, broadcast, rewritten, or redistributed.