Here are a couple of things to consider regarding pressure in addition to the excellent article from Primal Rights.

1) Case expansion. By measuring your cases above the web, you can track expansion as a result of pressure. Case expansion can be normal especially in short cases like the 6BR where the die isn't sizing the entire length of a case. Over time this leads to "clicky" bolt. A sign that the case is hard to pull out by the extractor. Rifles are all different so signs like ejector wipe may not appear as serious from rifle to rifle. Measuring case expansion can give you an objective way to detect pressure. Small body dies can be used to size the brass prior to full length resizing if you have "expanded" a few cases with a high pressure load. Case heads with wipe signs don't clean up as easy and hang around potentially leading people to believe they still have high pressure.

2) Pierced primers. Primers can be pierced by over pressure loads certainly but can also be pierced by bolts with large firing pin holes and small firing pins. Savage bolts are often built with small diameter pins and large holes. If your cartridge has small primers this can easily occur. Best remedy is to have the bolt "bushed" where the firing pin hole is reduced. I had this problem with a new to me used rifle that was piercing low pressure loads. I even tested some factory ammo to be add another data point. Sent the bolt to a pro to get bushed, problem solved.

"The more you know"...
_________________________
NRA Life Member
Voting member of "No Bad Days" club