Flesher
New member
I'm fairly new at reloading, and I think I made a mistake on a run of 6.5 CM ammo. I don't think I had the sizing die seated enough, and my bases are not properly sized. They will not cycle in my AR10. I have about a hundred of these loaded up.
My question is, If I took out the de-primer/neck sizer, from my die, would it be possible to re-size the outside casing to the full length, with the bullet in?
Experienced advise would be appreciated.
THX
My question is, If I took out the de-primer/neck sizer, from my die, would it be possible to re-size the outside casing to the full length, with the bullet in?
Experienced advise would be appreciated.
THX