Christensen Arms

Predator Masters using UBB.threads ™ Infopop Corporation.
PM Gear Moon & Weather

Welcome to the Predator Masters Forums
Be sure to visit the main Predator Master website at





PM Gear
PM Gear
PM Gear
The Official Predator Masters Search Engine
Search Predator Masters

Topic Options
#3252921 - 09/21/20 10:12 PM T/C Contender forearm???
parson Offline
Seasoned Member

Registered: 11/16/13
Posts: 473
Loc: North Dakota
I have a Bullberry carbine barrel. I had intended to get a Boyd’s thumbhole stock and forearm. Ran into a potential problem. Boyd’s says their carbine forearm mounting holes are 3 9/16 apart. My Bullberry barrel mounting holes are 3 1/8. Boyd’s pistol forearm holes are 3 1/8 so I asked them how long their forearms are, could I use their pistol forearm as a substitute on my carbine barrel and function ok. They don’t answer. Anybody have both and tell me how long each is?

Think I found the answer, found in the fine print, fine for these old eyes, Boyd’s pistol and carbine forearms are same length at 11 inches


Edited by parson (09/22/20 10:20 AM)

Top
#3255002 - 10/18/20 02:07 PM Re: T/C Contender forearm??? [Re: parson]
viper Offline
Die Hard Member II

Registered: 05/03/07
Posts: 1215
Loc: Tucson, Arizona
Look at bullberrys hanging system for forearms. The screw into the two holes in a barrel and have just one hole in the forearm. You could plug the original two holes with a wood plug or little polished piece of brass dowel polished and epoxied in.

Top



Moderator:  Infidel 762 

© Predator Masters™, All Rights Reserved. This material may not be published, broadcast, rewritten, or redistributed.