Kevinfarmer3456
New member
What is the best saw and jig setup to convert 300 Blackout from 223 Remington?
Converting 300 Blackout
- Thread starter Kevinfarmer3456
- Start date
Bowhntr6pt
Well-known member
No experience here... but I've watched a lot of videos on YouTube about it. The one below looks good.
Bowhntr6pt
Well-known member
Looks FAST...
Plant.One
Well-known member
there are a couple good jigs out there that mate up with the HF mini chop saw
this method uses the squirrle daddy jig and the lee quick trim system
this might be a quicker use jig, the VZ58 "fastest blackout jig"
either jig, paired with a trimming system like the lee and you should be styling
now if you're going to convert a lot and have a progressive... you can get a RT1500 power trimmer... and really go to town.
this method uses the squirrle daddy jig and the lee quick trim system
this might be a quicker use jig, the VZ58 "fastest blackout jig"
either jig, paired with a trimming system like the lee and you should be styling
now if you're going to convert a lot and have a progressive... you can get a RT1500 power trimmer... and really go to town.
I use the Harbor Freight mini chop saw and a cheap jig I found on Etsy.
300 BLK Jig
Combined with a Frankford Arsenal case trim & prep center, I can convert brass fairly quickly.
300 BLK Jig
Combined with a Frankford Arsenal case trim & prep center, I can convert brass fairly quickly.