10 Gauge Lead Ammo

[BillfromHighland]

Anyone know where I might find factory 10 gauge 3 1/2 inch lead BBs or maybe #4 buck? I'm looking for an alternative to the Heavy Shot and Dead Coyote loads as they are about $4+ for every trigger pull! Loved the old Federal Premium Copper Plated stuff but can no longer find it. I'm afraid that handloading may be my only option but I haven't done that in decades.

 

[obaro]

Every so often Midway will have a run of it. The last I got was from there a couple years ago.

 

[ackleyman]

Check Gunbroker.com

 

[robs]

Sent you a PM.

 

[BangPop]

You would be a whole lot better off to get set up to hand load for your big 10. You don't need a press if you roll crimp so it's relatively inexpensive to get going. You'll never have to search for ammo again.

 

[smortium]

Ableammo.com has any 10 ga. Loaded shotshells you need.

 

[SlickerThanSnot]

Originally Posted By: smortiumAbleammo.com has any 10 ga. Loaded shotshells you need.


nope. not for coyotes. not even close.

best bet is going to be reloading for a 10ga.

 

[SlickerThanSnot]

found these. $4.00 a pop but the Remington wingmaster hd is some really good stuff for coyotes.

https://www.gunbroker.com/item/738419608

 

[derbyacresbob]

If you reload your own 10 ga loads they will be better than factory loaded shells and they will cost less to make.

Lead BBB and lead "T" shot loads would be bad a$$ in a 10 ga, more penetration than lead BB shot and way more pellets per shell than number 4 buck loads.