Lower receiver tension screw

[longrange454]

Any body have a diagram as to where to drill and tape your lower for a tension screw? Palmetto State told me their lowers with the PA prefix were drilled and tapped. Not true.

 

[wormydog1724]

My Seekins lowers have it next to the grip screw.

 

[longrange454]

I wanted an idea of how far forward from the rear of the receiver inlet.

 

[44spl]

I don't have a number for you but mine is center line of the rear takedown pin hole and right behind the grip screw hole. Hope this helps.

 

[Widow maker 223]

Yup pull some measurements. Dead in the middle of the rear take down pin. I would use a set screw with a brass tip.

 

[longrange454]

Thanks for the replies.I was thinking the center of the rear take down, but wanted to make sure.