Pull down brass (new) neck concentricity issues?

DiRTY DOG

DiRTY DOG

Well-known member
New unfired pulled down brass, such as LC or hard to find cases specifically Fed 6.8spc. Any issues with necks being pulled out of alignment etc that can't be easily fixed with basic sizing and case prep operations? Will they be fine after 1x firing?

I've seen some pull down brass that have slightly (but visible) deformed oblong mouths from bullets that were not pulled straight up. Don't worry about it?

My plan is to anneal and FL size.

 
If your going to neck down the 6.8 to the 6x6.8 neck it down before you anneal them! other wise just anneal and size them and be done with it.
 
Not 6x6.8.
smile.gif
 
Originally Posted By: DiRTY DOGNot 6x6.8.
smile.gif


Lol... If your going smaller!! size them before you anneal them
wink.gif
 
Last edited:
Back
Top