which trigger out of the 2?

Quote:How hard is it to take out a trigger and re-install it?

Takes about 3 minutes and all you need is a punch to push the pins out.

There's a step-by-step guide here:

Build a lower guide

Go around 50% down the page and you'll see:

Installing a match trigger in your lower, step by step:
 
Actually it is fairly simple.Take it apart slowly keeping in mind where the parts fit.The trigger goes in first and then the hammer and spring.It takes alittle finess to line up the pins.
 
well I done the switch today. was a little disappointed the timney trigger was not a true 3# it was 3.5#
I am going to use this rifle more of a bench fun gun. but I will take it out in the woods a time or two.
its a cheap dpms b barrel with a rock river lower.

now i may send the 2 stage RR trigger to Mr Springfield and put it in my M4 del-ton AR and make a calling gun.
 
Back
Top