Disassemble an RCBS Uniflow?

kam582

kam582

New member
This is probably something that is right under my nose, but for the life of me I cannot figure out how to disassemble an RCBS Uniflow. It is new, and I need to clean the measuring cylinder. It came together, and I can't seem to figure out how to get it apart. Can anyone help?

Thanks
 
Isn't there an instruction booklet with it that shows you how to swap the large/small cylinders?

If not, here:

Uniflow booklet in pdf

The trick is to remove the large measuring screw out through the hopper, if I remember correctly. I only ever used the large cylinder one time, since the small one will handle everything I load for.
 
Evil Lurker has it right. Unscrew the lock ring and the collar for the adjustment post and then rotate the cylinder until you can see down the hole the powder drops into. Turn it upside down and the post should fall through the top of the hopper.
 
Quote:Thanks guys, finally got it.
thumbup1.gif


Those instructions are lacking.
 
Back
Top